Keep Leaves Out Before They Settle In.
Give your outdoor AC unit a cleaner off-season. The surrounding mesh catches leaves and larger yard debris before they collect inside the idle condenser.
PROTECT MY OUTDOOR AC
Turn the system completely off before covering it. Remove the entire cover before operating an air conditioner or heat pump.
Less Debris Inside. Less Cleanup Later.
Leaves trapped on an exposed grille are easy to see, but debris that falls farther inside can be difficult to reach. This cover gives seasonal debris a more accessible place to land.
Protection From Above— And Every Side.
Leaves do not arrive from only one direction. The box-shaped design surrounds compatible outdoor units across the top and all four sides, helping manage both falling and windblown debris.
Open Mesh That Doesn’t Trap the Outdoors.
The open-grid design intercepts leaves and larger debris while allowing water and fine particles to pass through. It is made for seasonal protection—not for use while the system is operating.
Fasten Securely. Remove in Seconds.
The buckle fastening helps hold the flexible cover in place while keeping seasonal inspections and service access simple. Watch how easily it positions, fastens and lifts away.
Unfasten and remove the cover whenever access is needed.
Finished edges support the flexible mesh construction.
See the cover in use
Position, fasten and lift away. Tap the heading above to hide or reveal the demonstration.
Fit the cover only when the unit is completely shut down and will not start automatically.
Measure Once. Know the Fit.
Measure the widest points of your outdoor condenser before ordering, including any areas affected by pipes or connections. The cover’s approximate dimensions are shown below.
Measurements are approximate. Always compare them with your unit before purchase.
Four Simple Steps for Seasonal Protection.
Check the fit, shut the system down, secure the cover and always remove it completely before the unit runs again.
Compare your condenser measurements with the cover dimensions.
Make sure the system is completely off before installation.
Place the cover over the unit and close the buckle securely.
Clear debris and remove the full cover before restarting.
Seasonal Coverage. Small-Space Storage.
When cooling season returns, clear away collected debris, make sure the cover is dry and fold it down for a garage shelf or seasonal storage bin.
Frequently Asked Questions.
Everything you need to know before covering your outdoor unit for the off-season.
Can I run my AC while the cover is installed?
No. This is an off-season cover for an idle unit. Remove it completely before operating an air conditioner or heat pump.
What type of debris does it help block?
It is designed to catch leaves, twigs and other larger yard debris. Fine dust and water may still pass through the open mesh.
Does it cover the entire outdoor unit?
The box-shaped design provides coverage across the top and all four sides of a compatible condenser.
What size is the cover?
The approximate size is 24.02 inches wide × 24.02 inches deep × 29.92 inches high, or 61 × 61 × 76 cm.
How should I clean it?
Remove loose debris with a soft brush or gentle shake. If needed, wipe or rinse the cover and allow it to dry completely before storage.
Can it be used on a heat pump?
Only when the heat pump is fully shut down and cannot start automatically. Remove the complete cover before the system runs.
Give Your Outdoor AC a Cleaner Off-Season.
Keep leaves and larger seasonal debris where you can see and remove them—before they settle deeper inside the idle unit.
CHOOSE MY AC COVEROff-season use only. Remove completely before operating the system.